- Suits standard worktop jig bolt recess.
- 170 mm overall length.
- Bolt balances on hex driver.
- Strong and powerful zinc plated metal bolts.
- Use a 5 mm hex driver to tension bolt.
- Durable diecast gear housing to allow higher torque levels.
- Saves time and money in assembling worktops.
- Patent number EP1969240.
- Set included:
- 3,25 or 50pcs x 170 mm ZipBolts
- 1 x 5 mm hex bit (50 mm) with 3 pcs set ONLY
Having fitted more worktops than I care to remember, I know only too well that it is always tricky getting under the top to tighten the bolts. Invariably the spanner slips or you have to be a contortionist to get into the cupboard below while having constantly to check the top surface for alignment. Trend’s Worktop ZipBolts don’t eliminate the acrobatics but they do speed up the connection as well as making it a whole lot easier into the bargain. The bolts are supplied with a 5 mm hex driver bit with a standard 1⁄4 in hex fitting so one can go directly into an impact driver or drill chuck. The ZipBolt locates snugly, allowing you to push up against it while it is in the routed slots, so ensuring a good connection before pulling the trigger. Gearing within the alloy head spins the shank of the bolt and pulls the free end up to the shoulder of the router recess. If you have long-enough arms you can reach in under the top and tighten the bolts without getting below, but ideally they are easier to position by getting under. Once they start to engage it’s easy to tweak each bolt so it just nips enough to allow you to tap the joint around until you achieve a perfect fit, and then fully tighten it. It takes a matter of seconds to fit and tighten a bolt into the recess once it’s routed, making these bolts an absolute must if you fit regularly or even just as a one-off. I’m now going to cost these into the next worktop job I have to do as they are such a boon!
Click & Collect Available 
£0 Fee on Returns 
Over 10k Products Available 
