Recently Viewed

Sensio 12V Driver with Port JB4 Distribution Block

Sensio 12V Driver with Port JB4 Distribution Block
Zoom  Zoom
Sensio 12V Driver with Port JB4 Distribution BlockSensio 12V Driver with Port JB4 Distribution BlockSensio 12V Driver with Port JB4 Distribution Block
Our Price:  £20.00(Inc. 20% VAT)(£16.67 Exc. VAT)

Bar Code:  SE40525
Part Number:  11642
Brand:  Sensio


FREE Delivery on order over £100*

Use this driver with ORANGE colour coded products from the Sensio range.
This electronic LED converter is exclusively designed for LED products which are to be used indoors. The electronic converter has a switch mode power supply with 12VDC constant output voltage.
An electronic protection circuit switches off the electronic converter in case of short circuit or overload in the secondary circuit, overheat as well as open circuit. This convertor is a thermally protected device, the type of protection is automatic reset. Once the load is reduced to sit within the suggested parameter the LED converter is ready for operation again.
Important information for the installation:
The unit conforms to the directive 2004/108/EC for the electromagnetic compatibility and the low voltage directive 2006/108/EC.

  • The electronic converter can only be used with the LED lamps.
  • The electronic converter is only suitable for use in indoors. Protect the electronic converter against excessive heat (permissible operating temperature range –20 to +40 degrees celcius).
  • The loads indicated on the converter must neither exceed nor below the following values: 0.5-30W.
  • Connect the LED lamps to the electronic LED converter with correct polarity according to the schematic drawing.
  • The maximum length of the output cable to the LED lamps should not exceed 8m in order to meet the EMC standard.
  • If the electronic LED converter is used for purposes other than originally intended or it is connected in the wrong way, no liability can be taken over for possible damages.

Input voltage: 220-240V~ 50Hz
Output voltage: 12VDC +1V/-0.2V
Rated power: 6W/15W/30W
Minimum load: 0.5W
Protection degree: IP20

Be the first to Write a Review for this item!

                                         Call us on: 01708751172 Mon - Fri 8am - 5pm, Sat 8am - 2pm
                                         FREE DELIVERY on all orders over £100*
Solmer Ltd